WARM PUMP (AIR - CONDITIONING + WARM WATER + CENTRAL HEATING)
|
WARM PUMP (AIR - CONDITIONING + WARM WATER + CENTRAL HEATING) |
|
|
|
|
|
What is the warm pump? Warm pump is device using cooling circulation similar to practical circulation in usual household fridges.
From where to take warmly to pumps warm - bottom source warm}. To them higher temperature of airs from which pump draws energy, this her efficiency is higher. Just from this of reason pump warm best to place on it used garret. There just across convection warm by ceilings and staircases gathers most of all warm. Additionally one can lead out on garret additional ventilating - lines( except WC and of kitchen) instead to lead out energy contained in "to waste - air" outside of building. Condition such locations of pump warm is however termical isolated roof. Warm pump one can also place in boiler room, where from attentions on exploitation of kettle is suitable temperature of airs.
Superiority of warm pump over traditional heater of water. At heating of water at use of warm pump wears away minimum 3, 5 time less of energy than at warming with electric warmer. Marks this, that of every 1kWh electric energy received from nets gives us 3, 5kWh of energy devoted water in figure warm. Being lacking 2, 5kWh of energy thermal pump gains over from energy contained in air, which chills. Additional effect of pump warm is drying rooms, in which is she exploited. Has this special meaning when pump works in rooms cellar - or pantries. Is this so device high esteemed on market from point of view ecology and saving of energy.
|
||
|
|
|||
|
|
|||
|
|
|||
Advantages:
|
|||
| Technical specification: | |||
| Type: | ROT1-500 | ||
| Power supply: | ~220V/ 50Hz | ||
| Capacity of the reservoir: | 500l | ||
| Regulation the temperature of water: | 35oC - 55oC | ||
| Received power: | 720W | ||
| Heating power of the warm pump: | 2520W | ||
| Heating effectivity of the warm pump: | min. 3,5 | ||
| Protection of the electric wires: | 10A | ||
|
|
|||
|
Nopressure, accumulation, flow warm exchanger + warm pump.
|
|||
|
Our firm offers for you not pressure, flow, acumulation exchanger warm supplied from many sources. Is he ideal for installation warm useful waters supplied from such sources how solar collectors, wind turbine, warm pump, home electropower station, fire-place with water overcoat, traditional kettle or other source warm. You can buy at us also in complete set with above-mentioned devices determining source warm. Exchanger this is produced by us, and his main advantage is this, that warm exchange takes place across working factor, which is under atmospherical pressure. Is he more safe and less damage. Our exchanger on capacity 500 of litres. At use only of solar collectors (surface 6m2) temperature 60oC attains oneself in the two hours time. After thirty minutes water is to use.
Advantages:
|
|
||
 |
|
|
